- Published on
🎱 Repair log: Eight Ball Deluxe LE (Bally, 1982)
Repair logs are quick summaries of workshop and on-site repairs. If your machine needs a service, 📬 Contact Us to discuss how we can help!
Hit the drops, hit the eight ball, and go for deluxe! Bit hard to do when you don't have working flippers, though! This game presented beautifully but the flippers were sporadic. Sometimes working, sometimes weak, sometimes not working at all. Flipper mechanisms themselves were fine. Time to look further into the backbox and wiring.
On early Bally and Stern games, flipper power starts at the rectifier board, goes through the cabinet switches, enters the solenoid driver board, passes through the flipper enable relay, and leaves the driver board and goes to the flipper coils. The relay is easy enough to test; just ground the tab of transistor Q15 and see if it clicks. It was good. So connectors were the next culprit. The connector on the bottom right of the driver board caused the flipper relay to click when it was wiggled. This was our dodgy connection! Header pins on the board were fine, but the terminals in the connector were not. Rebuilt the connector and flippers were back to full strength.
A couple of the pop bumpers were very weak. Time to give them a service. (I like the early Bally pop bumper design; very easy to pull out of the playfield for servicing!). Main issue here was a spacing issue with the spoon switches. They were pressed up hard against the wafer rod, which didn't allow it to move. No idea how that happened, but some extra switch spacers in the stack helped to space things out a little better. Switches cleaned, adjusted, and the coils were re-sleeved as well. Nice and snappy now.
A quick service is a good service! Plenty of time left for chalkin'...